![]() Use a finer mesh in the stress concentration area around a concave fillet or round to compensate for the lack of curvature. When cleared, produces meshes with straight elements, which can be a less accurate representation of the model. The smaller the angle, the greater the number of mesh elements on a curve.Ĭreates meshes with curved edges and faces. ![]() For example, a setting of 1.5 limits an elements edge length to 1.5 times the edge length of the adjacent element.Įffects the number of elements on curved surfaces. Specifies the maximum edge length ratio between adjacent element edges. The value is relative to the Average Size.ĭefault 0.2 Recommended Between 0.1 and 0.2Įffects the uniformity of the mesh transition between fine and coarse mesh. Specifies the element size relative to the model size.Īllows for automatic refinement in small areas. Smaller mesh elements take longer to simulate. These parameters specify the mesh sizing and coarseness. To view mesh settings, on the Ribbon: Stress Analysis tab Mesh panel, click Mesh Settings.For Parametric Dimension simulations, one mesh setting applies to all parameter ranges. Mesh settings are established for each simulation, and apply to the component in a global sense.
0 Comments
Leave a Reply. |